Tagged: Exadata Smart Flash Logging

Exadata Smart Flash Logging Explained

I’ve seen some posts on the blogosphere where people attempt to explain (or should I say guess) how Exadata Smart Flash Logging works and most of them are wrong. Hopefully this post will help clear up some the misconceptions out there.

The following is an excerpt from the paper entitled “Exadata Smart Flash Cache Features and the Oracle Exadata Database Machine” that goes into technical detail on the Exadata Smart Flash Logging feature.

Smart Flash Logging works as follows. When receiving a redo log write request, Exadata will do
parallel writes to the on-disk redo logs as well as a small amount of space reserved in the flash
hardware. When either of these writes has successfully completed the database will be
immediately notified of completion. If the disk drives hosting the logs experience slow response
times, then the Exadata Smart Flash Cache will provide a faster log write response time.
Conversely, if the Exadata Smart Flash Cache is temporarily experiencing slow response times
(e.g., due to wear leveling algorithms), then the disk drive will provide a faster response time.
Given the speed advantage the Exadata flash hardware has over disk drives, log writes should be
written to Exadata Smart Flash Cache, almost all of the time, resulting in very fast redo write
performance. This algorithm will significantly smooth out redo write response times and provide
overall better database performance.

The Exadata Smart Flash Cache is not used as a permanent store for redo data – it is just a
temporary store for the purpose of providing fast redo write response time. The Exadata Smart
Flash Cache is a cache for storing redo data until this data is safely written to disk. The Exadata
Storage Server comes with a substantial amount of flash storage. A small amount is allocated for
database logging and the remainder will be used for caching user data. The best practices and
configuration of redo log sizing, duplexing and mirroring do not change when using Exadata
Smart Flash Logging. Smart Flash Logging handles all crash and recovery scenarios without
requiring any additional or special administrator intervention beyond what would normally be
needed for recovery of the database from redo logs. From an end user perspective, the system
behaves in a completely transparent manner and the user need not be aware that flash is being
used as a temporary store for redo. The only behavioral difference will be consistently low
latencies for redo log writes.

By default, 512 MB of the Exadata flash is allocated to Smart Flash Logging. Relative to the 384
GB of flash in each Exadata cell this is an insignificant investment for a huge performance
benefit. This default allocation will be sufficient for most situations. Statistics are maintained to
indicate the number and frequency of redo writes serviced by flash and those that could not be
serviced, due to, for example, insufficient flash space being allocated for Smart Flash Logging.
For a database with a high redo generation rate, or when many databases are consolidated on to
one Exadata Database Machine, the size of the flash allocated to Smart Flash Logging may need
to be enlarged. In addition, for consolidated deployments, the Exadata I/O Resource Manager
(IORM) has been enhanced to enable or disable Smart Flash Logging for the different databases
running on the Database Machine, reserving flash for the most performance critical databases.